California’s AB 38 Home-Hardening Disclosure: What Sellers Must Give Buyers

House nestled against a tree-covered hillside, the kind of terrain mapped as a California fire hazard severity zone under AB 38

AB 38 requires sellers of homes built before January 1, 2010 in a California high or very high fire hazard severity zone to hand buyers a specific written disclosure before escrow closes, listing known wildfire vulnerabilities and, as of July 1, 2025, which low-cost retrofits the home already has. The law does not force anyone to fix those vulnerabilities before selling; it only forces them to put what they know in writing.

That distinction trips up a lot of sellers, because the press coverage around California’s wildfire-mitigation laws tends to blur “disclose it” with “fix it.” They are not the same obligation, and mixing them up either scares people into retrofits they do not legally need before a sale, or leads them to skip a disclosure they absolutely do need.

Here is what Assembly Bill 38 actually says, which statutes it lives in, and what a seller in a mapped fire zone should do with that information.

Which Homes AB 38 Actually Covers

AB 38’s point-of-sale disclosure applies when two conditions are both true: the property sits in a High or Very High Fire Hazard Severity Zone, as mapped by the Director of Forestry and Fire Protection (Government Code Section 51178) or under the wildland fire protection provisions of the Public Resources Code, and the home was built before January 1, 2010 — before the state’s Wildland-Urban Interface building code requirements existed.

The statute applies to one-to-four-unit residential real property sold under California’s standard transfer-disclosure article, which covers the overwhelming majority of single-family home and small residential sales statewide.

Fire hazard severity zones are mapped everywhere in the state, not just in the mountains or in areas that have already burned.

CAL FIRE maintains separate map layers for State Responsibility Areas (SRA), which are the wildland areas the state itself is responsible for protecting, and Local Responsibility Areas (LRA), which are generally incorporated cities and towns where a local fire department has primary responsibility.

In an SRA, both High and Very High zones are mapped and carry regulatory weight. In an LRA, only Very High zones are currently designated for most regulatory purposes.

A lot of LRA cities most people would not think of as “fire country” — foothill suburbs, parts of cities built against open space or wildland edges — have Very High-designated pockets, so the only reliable way to know whether a specific address is covered is to check the parcel, not the city’s reputation.

The Disclosure AB 38 Requires, and Where It Comes From in the Law

AB 38 was signed in 2019 and its seller-disclosure provisions took effect January 1, 2021. The operative language lives in California Civil Code Section 1102.6f, inside the same disclosure article that governs the familiar Real Estate Transfer Disclosure Statement.

Section 1102.6f pulls in two Government Code provisions for its substance: Section 51178, which is how fire hazard severity zones get mapped in the first place, and Sections 51182 and 51189, which define defensible space standards and the low-cost retrofit list referenced inside the disclosure itself.

Under Section 1102.6f, a covered seller must give the buyer a disclosure notice containing three distinct pieces:

  1. A standardized statement, written into the statute word for word, explaining that the home sits in a high or very high fire hazard severity zone, was built before the Wildfire Urban Interface codes existed, and pointing the buyer to readyforwildfire.org for information on fire hardening and vegetation management standards.
  2. As of July 1, 2025, a checklist of the low-cost retrofits developed under Government Code Section 51189, with the seller indicating which of those retrofits, if any, were completed while they owned the property.
  3. A list of specific features that make a home more vulnerable to embers and wildfire, with the seller disclosing which of those features exist on the home, to the best of their actual knowledge.
  4. If the seller separately obtained a final defensible space inspection report under Government Code Section 51182 — something that mainly comes up after new construction or a rebuild in a locally designated Very High zone — the statute also requires handing over a copy of that report, or telling the buyer where to get one.

    Most resale sellers of older homes have never had this kind of inspection done and are not required to get one just to satisfy the disclosure.

    The Specific Vulnerabilities You Must Disclose

    The vulnerability checklist in Civil Code Section 1102.6f lists six specific conditions. A seller discloses which ones they are actually aware exist on the property — the law does not require an inspection to find out, only honesty about what the seller already knows:

    • Eave, soffit, and roof vents with openings larger than one-eighth of an inch, or vents that are not flame- and ember-resistant
    • Roof coverings made of untreated wood shingles or shakes
    • Combustible landscaping or other combustible materials within five feet of the home, or under the footprint of an attached deck
    • Single-pane or non-tempered glass windows
    • Loose or missing bird stopping or roof flashing
    • Rain gutters without metal or noncombustible gutter covers
    • None of these require a professional opinion to spot. Single-pane windows and wood shake roofs are usually obvious from a walkthrough; vent mesh size and gutter covers take a closer look but nothing a seller, agent, or home inspector can’t eyeball. The disclosure is about what you know, not what a specialist would find if you paid for an inspection you were never required to order.

      The July 2025 Retrofit Checklist That Was Added to the Form

      AB 38’s disclosure rolled out in two stages. The base statement and the vulnerability checklist took effect January 1, 2021. The second piece — the low-cost retrofit checklist built from the list the State Fire Marshal was directed to develop under Government Code Section 51189 — was added to the required notice effective July 1, 2025.

      That list includes items like replacing a roof with a Class A fire-rated covering, installing ember-resistant attic and crawl-space vents, sealing gaps at roof lines with noncombustible bird-stop material, and screening skylights and other openings with noncombustible metal mesh.

      Because that July 2025 effective date has already passed, every covered sale closing today needs the full three-part notice, not the older two-part version some sellers may remember from a prior listing. An outdated disclosure form that only covers the original 2021 language is no longer compliant on its own for a home that qualifies under AB 38.

      What the July 2025 expansion did not do is turn the retrofit list into a requirement. Sellers disclose which retrofits are present, including “none,” and that is a complete, lawful answer. The checklist exists to inform the buyer, not to gate the sale behind a renovation project.

      Is a Defensible Space Inspection Mandatory, or Just the Paperwork?

      This is where the two separate legal tracks are easiest to confuse.

      Government Code Section 51182 imposes an ongoing maintenance duty on people who own, lease, or operate an occupied dwelling inside a locally designated Very High fire hazard severity zone: maintain 100 feet of defensible space around the structure, with a more ember-resistant standard required within the first five feet, keep the roof clear of debris, and keep overhanging vegetation free of dead wood.

      That duty exists independent of whether the home is for sale, and local agencies can enforce it with citations, abatement, and liens.

      A formal, documented “final inspection report” under that same section is tied mainly to new construction and rebuilds in those zones, where the builder has to show compliance with applicable building standards before and after the work is done.

      For an ordinary resale of an existing home, there is no statewide mandate requiring the seller to schedule a defensible space inspection, pass one, or produce a certificate of compliance before closing escrow, as of the current law.

      The Civil Code 1102.6f disclosure duty runs on actual knowledge of the listed vulnerabilities and retrofits, not on inspection results a seller never had to obtain in the first place.

      That said, a local vegetation-management or defensible-space ordinance adopted by a city, county, or fire district can impose its own inspection or compliance requirements on top of the state disclosure law, and some high-risk communities have exactly that kind of program. A seller in a mapped zone should ask the local fire department or fire protection district, not assume the statewide rule is the only rule that applies.

      Home Hardening and the 100-Foot Defensible Space Standard

      “Home hardening” and “defensible space” get used almost interchangeably in casual conversation, but they describe two different kinds of work.

      Defensible space is about the land: clearing dead vegetation, spacing shrubs and trees so fire can’t climb from one to the next, mowing dry grass, and removing fuel that would let a ground fire reach the structure.

      The state’s standard calls for 100 feet of maintained space around a structure where terrain allows, with the heaviest fuel reduction concentrated between 5 and 30 feet from the building and an even stricter “ember-resistant zone” required within the first 5 feet — the zone where wind-driven embers are most likely to land and ignite something touching the house itself.

      Home hardening is about the structure itself: Class A fire-rated roofing, ember-resistant vents, enclosed eaves, dual-pane or tempered windows, noncombustible decking and siding near the building, and metal mesh over any opening embers could enter.

      The six vulnerabilities on the AB 38 disclosure checklist and the retrofit list added in 2025 are essentially a plain-language shorthand for home-hardening basics, aimed at buyers rather than contractors.

      Neither defensible space nor home hardening work is required by AB 38 itself before a sale; the law requires telling the buyer where things stand, not bringing the property up to a state standard first.

      How to Check Whether a Property Sits in a Fire Hazard Severity Zone

      Because the disclosure obligation turns entirely on the mapped zone and the home’s construction date, the first real step for any seller is confirming both facts for the specific parcel, not for the neighborhood in general.

      CAL FIRE’s Fire Hazard Severity Zone viewer lets you search by address and shows whether the parcel falls in a Moderate, High, or Very High zone, and whether that zone sits in an SRA or an LRA.

      County assessor records or the original permit file will usually confirm the year a home was actually built, which matters because a home built in 2011 on a lot that was later rebuilt after a fire can have a different effective construction date than the listing assumes.

      It’s worth running this check even if a seller has sold or bought in the same area before. CAL FIRE updates its hazard severity zone maps periodically as fuel conditions, development patterns, and fire history change, so a parcel that was outside a mapped zone several years ago is not guaranteed to be outside it today, and the reverse is also true.

      What Happens When a Seller Skips or Botches the Disclosure

      California’s disclosure statutes generally give the buyer a right to walk away and get their deposit back if a required disclosure is delivered late, or not delivered before the transaction closes, and they can rescind within a set window after receiving it.

      Beyond the immediate escrow mechanics, an inaccurate or omitted fire disclosure can resurface after closing as a nondisclosure or misrepresentation claim, particularly if a buyer later discovers a condition the seller plainly should have known about, like a wood shake roof visible from the street or single-pane windows throughout the home.

      Agents and sellers are generally expected to use whatever current disclosure form reflects the law as it stands at the time of the transaction. A form that predates the July 2025 retrofit-checklist expansion, used on a sale closing today, is missing a piece the current statute requires.

      That is an easy mistake to avoid simply by confirming the paperwork has been updated since mid-2025, rather than reusing whatever packet was on file from an earlier listing attempt.

      When Hardening Before You List Isn’t Worth the Money

      Because AB 38 is a disclosure law and not a retrofit mandate, a seller is legally free to list a home with every one of the six vulnerabilities present, as long as they say so honestly.

      That changes the math on whether to spend money hardening the property before putting it on the market, and for a lot of sellers in fire-prone areas, the honest answer is: not yet, and maybe not at all.

      A full re-roof with Class A materials, new dual-pane windows throughout, and vent replacement can run well into five figures on an older home, and none of it is required to close a sale.

      If the house itself needs more than cosmetic work — structural issues, deferred maintenance stacked on top of the fire-hardening gaps, or damage from a prior fire or other event — spending retrofit money before listing can mean sinking cash into a property that a buyer may gut or rebuild anyway.

      That math gets worse the closer a property is to teardown condition: dollars spent on ember-resistant vents and gutter guards do nothing for a buyer planning to demolish and rebuild, and they rarely return dollar-for-dollar in a market where buyers in these zones are already pricing in insurance uncertainty.

      Where hardening work can pay off is when a home is otherwise in solid shape, the retrofits are genuinely low-cost (gutter covers, vent screens, clearing the first five feet), and the seller has time before listing and isn’t trying to solve an insurance nonrenewal on a deadline.

      Where it tends not to pay off is anywhere the underlying property condition, timeline, or insurance situation makes a traditional sale an uphill climb in the first place — and in those cases, an honest AB 38 disclosure paired with an as-is sale is usually the more realistic path than a renovation budget the sale price won’t return.

      What a Seller Should Actually Do Before Listing

      Start by confirming the parcel’s Fire Hazard Severity Zone status and construction date, since that determines whether AB 38’s disclosure even applies.

      If it does, walk the property against the six-item vulnerability list and the 2025 retrofit checklist and note honestly what’s present and what isn’t — guessing or leaving items blank is worse than disclosing a vulnerability the buyer will likely spot anyway.

      If the home is in a locally designated Very High zone, check with the local fire department or fire protection district about any additional vegetation-management or inspection ordinance layered on top of the state requirement.

      It’s also worth thinking about insurability separately from the disclosure itself.

      Insurers writing policies in high and very high fire hazard zones increasingly factor defensible space and home-hardening features into underwriting decisions, and a property that’s been declined or nonrenewed by standard carriers may end up insured through California’s FAIR Plan, the state’s insurer of last resort for properties that can’t get coverage on the open market.

      That’s a conversation for a seller to have with an insurance agent or broker, not something AB 38 itself resolves — the disclosure law tells the buyer what’s known about the property; it doesn’t guarantee the buyer can insure it.

      If the retrofit math doesn’t pencil out, or the house has other problems that make a conventional listing, inspection period, and buyer financing contingency more trouble than it’s worth, a no-obligation cash offer is one way to move a property in a fire hazard zone without putting money into upgrades a traditional buyer might not even value.

      You can request one directly through Cash Home Buyers CA, and if you’d like to see how we work with other California sellers first, you can find our Google Business Profile and go from there — reach us anytime at (424) 435-2326.